Shake Your Sockies

What can you do with all those leftover ends of luscious and beautiful sock yarn? You can shake your booties, of course!sockies

A quick and easy newborn-size baby bootie pattern designed for fingering weight sock yarns. If you’d like bigger booties (say 6-9 month size), you could experiment with a sport-weight yarn and the appropriate sized needles.

Finished Size:
To fit newborn – 3 months (approx. 3.5” from heel to toe)

Fingering weight sock yarn; approximately 70-75 yards
1 pair US 1 (2.25mm) straight needles
1 large-eyed tapestry needle
¼” ribbon (less than 1 yd) to tie booties

About 30 sts to 4 inches: gauge is not critical to these, but it will affect the finished size of the booties.

inc – increase by knitting into the front and back of the next stitch
k2tog – knit next 2 stitches together
p2tog – purl next 2 stitches together
st(s) – stitch(es)
tbs – through back of stitch(es)
yo – yarn around needle

Using your preferred cast on (I use the long-tail for these), cast on 51 sts.
Rows 1-6: work in garter stitch (every row knit).
Row 7 (increase): k1, inc, k22, inc, k1, inc, k22, inc, k1 (55 sts).
Rows 8 & 10: work in garter stitch.
Row 9 (increase): k1, inc, k24, inc, k1, inc, k24, inc, k1 (59 sts).
Rows 11 – 20: work in garter stitch.
Row 1: k32, k2tog tbs, turn.
Row 2: p6, p2tog, turn.
Row 3: k7, k2tog tbs, turn.
Row 4: p8, p2tog, turn.
Row 5: k9, k2tog tbs, turn.
Row 6: p10, p2tog, turn.
Row 7: k10, k2tog tbs, turn.
Continue instep as above (decreasing and turning after knitting or purling 10 sts each time), until 43 sts remain (16 sts either side of instep sts).
Next row: k10, k2tog tbs, k to last 2 sts, k2tog.
Next row: p24 (to last st of instep sts), p2tog, p to last 2 sts, p2tog (41 sts).
Row 1: work in rib: p1, k1; rep. to last st, p1.
Row 2: work in rib: k1, p1; rep. to last st, k1
Row 3: make ribbon holes: k2, *yo, k2tog, repeat from * to last st, k1.
Row 4: purl.
Rows 5 and 6: repeat rows 1 and 2.
Rows 7-17: work in garter stitch.
Cast off loosely (on the wrong side), leaving enough of a tail to sew the seam.

Using the yarn tail left, sew the seam, then turn the bootie out the right way.
Thread the ribbon through the ribbon holes and tie firmly (you can put a couple of stitches through the center of the bow using matching sewing cotton if you are worried about the ribbon coming loose or untied).
Put the booties in a gift bag and be prepared for rave reviews ?

Make sure all trim on booties is firmly tied/sewn/attached as ribbons, pompons, jingle bells, beads, buttons, etc. may present a choking hazard – adult supervision is recommended while babies are wearing booties with any embellishments.

Hand wash recommended (remove ribbon first!); dry flat.

If you want your booties to look like a matched pair, make a note of what stage of the variegated pattern in the yarn you start with for the first bootie. Try to match this for the second. If you like randomness, just cast on without a care!

Pattern & images ©2009 by Kathie Popadin


One thought on “Shake Your Sockies

Leave a Reply

Your email address will not be published. Required fields are marked *

You may use these HTML tags and attributes: <a href="" title=""> <abbr title=""> <acronym title=""> <b> <blockquote cite=""> <cite> <code> <del datetime=""> <em> <i> <q cite=""> <strike> <strong>